|
FURNACE HEATER
|
Honeywell Furnace Problems And Reviews
Best honeywell furnace information
My honeywell furnace electric ignites but the gas does not start a minutes later the fan turns on but no heat?
the electric ignitor glows but i have no heat flames in my furnace. minutes later the fan turns on blowing cold air. what am i looking at for repair options if this isnt something i can fix on my own?
My honeywell furnace will not open the main gas valve?
I have been having the trouble for little while now.The unit will run normally and then something trips after 3 20 mins and shuts off the main valve along with the rest of the unit except the exhaust blower motor. Upon restart, the unit will fire up like normal until the pilot lights. It will stay lit, however the main valve will not open to ignite the burners and the process stalls out there. The unit must sit for about 1 5 hours before restarting properly.It has a S86F intermittent pilot module.All the grounds have been checked that I could see and I have narrowed it down to the main board, the gas valve itself and the pilot module from my non expertise.Any advise? Note, the fan limit unit was replaced, but this problem seemed to occur about 4 months after.It is a NG system.There is an ignitor for the pilot and it will spark that up and then it shuts off the spark so it knows there is a flame present for the pilot.I am guessing that becasue it stops trying to ignite the pilot, it's not the flame sensor right? It signals for the pilot being lit by completing the ground circut with the pilot flame.With the limit switch...the triggers are at 75 120 175 fan shutoff fan turn on burner on burner shutoffIt seems to be functioning normally and will go between triggers 2 and 3 cycling through lighting and killing the burner
Get massive exposure - submit articles to FREE directory
Were do i find a honeywell furnace maual on a model number gun050-2b?
on the cover it says the dependable ninety plus
Cannot get my honeywell furnace to work?
I have a HonEywell furnace. It has autopilot, and it is suppossed to start automatically.I followed the steps that are written on the door inside...1 turn the electrical supply OFF2 put the thermostat to minimum3 turn autopilot to OFF position4 keep it like that fo 5 min5 turn the autopilot to ON6 turn the electrical supply ON 7 increase the temperature on the thermostat
How do you adjust interval settings on a honeywell furnace thermostat?
My honeywell furnace will not come on at all?
My honeywell furnace ignites and fires but shuts right back down?
i tried to bypass the therostat. the fan turned on the pilot lit my flame starts then it just shuts down. it keeps trying to start up but does not say burning
I have a honeywell furnace, the blower only works with heat, not A/C?
i have a honeywell furnace and the blower motor only kicks on with heat, when using A C the blower motor never kicks on, the Central air unit outside is working just fine. and also the Flash Code LED Indicator in the furnace is giving me a steady green flash which means its operating normally, what could this be?I believe its the transformer in the furnace, if i disconnect the power to the transformer and reconnect it over and over the blower ends up kicking on, but kicking off very shortly after, where could i get a replacement transformer?Its not the thermostat, simply because i get it to kick on by playing with the transformer, and the staus codes for LED states, " Steady Green Flashes" means normal operation, and thats what i have is steady green flashing.
|
|
